{{tag>project}}
===== LoTHR mini Electronics Soldering Station =====

=== Parts ===

  * [[https://www.aliexpress.com/item/DP30V5A-Constant-Voltage-current-Programmable-Power-Step-down-Supply-module-Ammeter-buck-regulator-converter-voltmeter/32656627324.html | DP30V5A/DSV3005]]
  * [[https://www.aliexpress.com/store/product/KSGER-T12-Soldering-Iron-Station-MIni-STM32-OLED-V2-01-DIY-Kits-FX9501-Electric-Tools-Aluminum/1486111_32948842049.html | KSGER T12 mini Soldering Station]]
    * Backside Switch re-used on front
  * [[https://www.thingiverse.com/thing:2817722 | T12 Tip Holder]]
  * [[https://www.conrad.at/de/schuetzinger-seb-6452-ni-sw-sicherheits-laborbuchse-buchse-einbau-vertikal-stift-o-4-mm-schwarz-1-st-1537941.html| 4x Safety Laboratory Banana Jack]]
  * old external SCSI HDD Case
  * 2x 5pin Jumper-Wire Jack
  * Switching power supply 24V / 3.2A, set to ~27V
  * [[https://de.aliexpress.com/item/35-watt-elektronische-last-einstellbare-konstante-strom-aging-widerstand-batterie-spannung-kapazit-t-tester-LCD-spannung/32954356498.html | XY-FZ35 Electronic Load]]
  * 1x USB Serial TTL Converter
  * 3x Jumper Wires

=== Manual ===

[[realraum:minielectronicsworkstationmanual]]

=== Photos ===

https://galley.realraum.at/index.php?/category/184

=== Blog Posts ===

  * https://wp.realraum.at/2019/01/lothr-mini-electronics-workbench/
  * https://wp.realraum.at/2019/02/lothr-mini-electronics-workbench-upgrade/


=== Front ===

The front was lasercut to accommodate the different devices.

  * Black: cut with 90% 60W at 10mm/s
  * Red: scan-engraved with 18% 60W at 100mm/s

{{ :xro:loetstationlabornetzteillothrbox3.svg |}}